Find the most up-to-date version of DS/EN at Engineering BS EN Flanges and their joints. Gaskets for class-designated flanges. Covered serrated metal gaskets for use with steel flanges. DIN EN Flanges and their joints – Gaskets for class-designated flanges – Part 6: Covered serrated metal gaskets for use with steel.
|Published (Last):||9 July 2004|
|PDF File Size:||8.99 Mb|
|ePub File Size:||2.22 Mb|
|Price:||Free* [*Free Regsitration Required]|
Non-metallic PTFE envelope gaskets. Corrugated, flat or grooved metallic and filled metallic gaskets for use with steel flanges Part 5: Take the smart route to manage medical device compliance.
For sizes below NPS 1. This website is best viewed with browser version of up to Microsoft Internet Explorer 8 or Firefox 3.
To reduce the possibility of vibration induced cracking of the core, the radius at the bottom of the grooves shall be as large as possible. Compliance with a British Standard does not of itself confer immunity from legal obligations. Gaskets for class-designated flanges.
The sealing element consists of a metal core with serrated top and lower surfaces and a conformable sealing material adhered to each serrated surface.
Users are responsible for its correct application. In service the thickness of the sealing material over the serrations is minimal, often about 0,1 mm.
The weight per unit area shall be such that metal to metal contact between the tips of the serrations and the flange surface is avoided. The number of welds shall not be more than two. In this case it is recommended that a colour code be agreed between the two parties. Users should note that the centring of an inside bolt circle gasket in an assembled Class designated flange joint will be affected when using metric bolting. Joints metalliques stries revetus pour utilisation avec des brides en acier Title in German Flansche und ihre Verbindungen.
The facing material may be cut from sheet to the appropriate size, applied in the form of texturised tape or by any other means em meets the other requirements of this standard. This document includes a Bibliography.
BS EN 12560-6:2003
Covered serrated metal gaskets for use with steel flanges. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision.
Sealing element with no locating ring b Type IR: This publication does not purport to include all the necessary provisions of a contract. Dichtungen fuer Flansche mit Class-Bezeichnung. Sealing element with integral location ring.
Revisions British Standards are updated by amendment or revision. The material of the loose location ring may be carbon steel. NOTE 2 Annex A lists information that should be supplied by the purchaser when ordering gaskets in circumstances where the choice of the gasket materials appropriate to the service is left to the supplier. The core thickness measured over the tips of the serrations shall be a minimum of three times the depth of the serrations.
It is incorporated e Royal Charter. Joints 1260-6 stries revetus pour utilisation avec des brides en acier. Worldwide Standards We can source any standard from anywhere in the world.
EN – European Standards
Information on cookies usage. For sizes above NPS 1. Amendments issued since publication Amd. Various BSI electronic information services are also available which give details on all its products and services. Ignoring the effects of the thickness of any adhesive and the grooving of the flange surfaces, the target weight per unit area of facing can be estimated from the following: The sealing face shall also 15260-6 free of surface blemishes, defects and damage that would impair the sealing performance of the gasket.
Large diameter gaskets shall be securely mounted on a carrier board or within a protective framework. Spiral wound gaskets for use with steel flanges.